ONKYO TX-NR801 Manuel D’Utilisation

Using the Macro Function—Continued

Perform the procedure below to execute the macro that
you have programmed into the remote controller. After
programming the macro, you should always run it at
least once to make sure that it has been programmed
properly.

Erasing a macro from the MACRO 1 (or 2) button

Notes:
• If the SEND/LEARN indicator quickly flashes three

times and turns off, then the remote controller has
exited the erasing mode because either you have
made a mistake during erasing or a time-out has
occurred because no button was pressed. Resume
from Step 1.

• If you press a button other than MACRO 1 (or 2) but-

ton in Step 2, then you will in effect be overwriting
the previous macro with a new macro.

Erasing all commands and macros that have
been programmed

This procedure will erase all the commands and macros
that you have programmed into the remote controller
and return it to its default settings. This operation will
not affect the preset settings of the remote controller.

All programmed commands and macros are erased and
the remote controller returns to its factory presets.

Notes:
• Proceed to Step 3 immediately after Step 2; other-

wise, the batteries will be consumed quickly.

• If you press any button other than the ENTER/ZONE

2 button in Step 3, nothing will be erased. In this
case, resume from Step 1.

Macro mode programming memo

Executing the Macro

Point the remote controller at the
TX-NR801/TX-NR801E.

Press the MACRO 1 (or 2) button.
It may take a while for the macro to finish trans-
mitting, so be sure to continue pointing the
remote controller at the device until the SEND/
LEARN indicator turns off.

Press and hold down any one of the 8
MODE buttons, press the MACRO 1 (or 2)
button, and then release both buttons.
When you press the MODE button, it lights and
the SEND/LEARN indicator lights. When you
press the MACRO 1 (or 2) button, the indicator
turns off. When you release the buttons, the indi-
cator flashes once.

Press the MACRO 1 (or 2) button again.
The SEND/LEARN indicator slowly flashes
twice. The macro programmed to the MACRO
button is erased.

Open the battery cover and remove the
batteries from the remote controller.

While pressing and holding down the ON
and STANDBY buttons, re-insert the bat-
teries in their correct orientation, and then
release both buttons.
The SEND/LEARN indicator flashes slowly.

Press the ENTER/ZONE 2 button.
The SEND/LEARN indicator lights up for about
ten seconds and then turns off.

MACRO 1

MACRO 2