ONKYO TXNR525 Manuel D’Utilisation

• Turning on the AV receiver may cause a momentary power 

surge that might interfere with other electrical equipment on 

the same circuit. If this is a problem, plug the AV receiver 
into a different branch circuit.

• Do not use a power cord other than the one supplied with 

the AV receiver. The supplied power cord is designed 
exclusively for use with the AV receiver and should not be 
used with any other equipment.

• Never disconnect the power cord from the AV receiver 

while the other end is still plugged into a wall outlet. Doing 
so may cause an electric shock. Always disconnect the 
power cord from the wall outlet first, and then the AV 
receiver.

• The HYBRID STANDBY indicator may light depending on 

the status of settings.

• For details on power management settings, see “Auto 

When a new version of the firmware is available, the 
notification window “Update New F/W” pops up. This 
notification only appears when the AV receiver is 
connected to the Internet (

). To perform 

the firmware update, follow the instructions on 
screen.

Use 

q/w and ENTER on the AV receiver or remote 

controller to select one of the options.

`

Update Now:

Starts the firmware update.
Refer to “Firmware Update” (

`

Remind me Later:

The update notification will pop up again the 
next time you turn the AV receiver on.

`

Never Remind me:

Disables the automatic update notification.

• The update notification window can be enabled or disabled 

in “Update Notice” (

By way of optimized circuitry, this function reduces 
power consumption when the AV receiver is in 
standby mode. The HYBRID STANDBY indicator will 
light in either of the following conditions:

–“HDMI Through” is enabled and Zones are turned 

off (the HDMI indicator is off).

–“Network Standby” is enabled and Zones are 

turned off (the NET indicator is off).

To AC wall outlet

8ON/STANDBY on the front panel.

or

8RECEIVER on 

the remote controller.
The AV receiver comes on and its display lights.

8ON/STANDBY on the front panel.

or

8RECEIVER on 

the remote controller.
The AV receiver will enter standby mode. To 
prevent any loud surprises when you turn on the 
AV receiver, always turn down the volume before 
you turn it off.