ONKYO TXNR525 Manuel D’Utilisation
Playback
En-39
You can display various information about the current
input source as follows.
input source as follows.
The following information can be typically displayed.
*1
When AM or FM radio is used, the band, preset number,
and frequency are displayed.
and frequency are displayed.
*2
If the input signal is digital, the signal format is displayed.
Information is displayed for about three seconds, then
the previously displayed information reappears.
Information is displayed for about three seconds, then
the previously displayed information reappears.
With the sleep timer, you can set the AV receiver to
turn off automatically after a specified period.
turn off automatically after a specified period.
You can adjust the brightness of the AV receiver’s
display.
display.
When you connect an
u-capable Onkyo
component, you must configure the input display so
that
that
u can work properly.
You can temporarily mute the output of the AV
receiver.
receiver.
Displaying Source Information
1
Press RECEIVER once followed by DISPLAY
repeatedly to cycle through the available
information.
repeatedly to cycle through the available
information.
Tip
• Alternatively, you can use DISPLAY on the AV
receiver.
Sampling
Input source
& volume
Signal
format
Listening
mode
Using the Sleep Timer
1
Press RECEIVER once followed by SLEEP
repeatedly to select the required sleep time.
The sleep time can be set from 90 to 10 minutes
in 10 minute steps.
The SLEEP indicator lights on the AV receiver’s
display when the sleep timer has been set. The
specified sleep time appears for about 5
seconds, then the previous display reappears.
repeatedly to select the required sleep time.
The sleep time can be set from 90 to 10 minutes
in 10 minute steps.
The SLEEP indicator lights on the AV receiver’s
display when the sleep timer has been set. The
specified sleep time appears for about 5
seconds, then the previous display reappears.
Tip
• If you need to cancel the sleep timer, press SLEEP
repeatedly until the SLEEP indicator goes off.
• To check the time remaining until the AV receiver
sleeps, press SLEEP. Note that if you press again on
SLEEP as the time being displayed is 10 minutes or
less, the sleep timer will go off.
SLEEP as the time being displayed is 10 minutes or
less, the sleep timer will go off.
Setting the Display Brightness
1
Press RECEIVER once followed by DIMMER
repeatedly to switch between: normal, dim, or
dimmer brightness.
repeatedly to switch between: normal, dim, or
dimmer brightness.
Tip
• (North American and Taiwanese models)
Alternatively, you can use DIMMER on the AV
receiver.
receiver.
Changing the Input Display
1
Change the name of the input selector to
“DOCK” or “TAPE”.
“DOCK” or “TAPE”.
Tip
• See “Name” in “8. Source Setup” for changing the
name (
Note
• “DOCK” and “TAPE” cannot be selected for the input
selector at the same time.
• Enter the appropriate remote control code before using
the remote controller for the first time (
).
Muting the AV Receiver
1
Press RECEIVER followed by MUTING.
The output is muted and the MUTING indicator
flashes on the AV receiver’s display.
The output is muted and the MUTING indicator
flashes on the AV receiver’s display.
Tip
• To unmute, press MUTING again or adjust the volume.
• Muting is automatically cancelled when the AV
• Muting is automatically cancelled when the AV
receiver is set to standby.