PYLE Audio PWMA100 Manuel D’Utilisation

1. POWER SUPPLY

a. AC power: Please confirm your current AC power is 

         same as the voltage marked on the device. 

b.DC power: DC power can be input from DC IN jack. If you 

        use car battery, the power should be 12V-15V. Please 

        note the correct polarity.

    C. Built-in rechargeable battery: you can also use built-in 

         rechargeable battery. 

2. Turn on power switch of amplifier,  power indicator will light.

3. Open the battery cover of the transmitter. Put a 9V battery 

into battery compartment and  then close the battery cover. 

Keep transmitter at least 1M from the receiver to prevent 

feedback. Turn on transmitter, RF indicator on receiver will 

light. Adjust wireless microphone volume to suitable level. 

The wireless system is now ready  to use. 

4. Wired MIC can connect to MIC in jack and its volume can 

be adjusted separately.  Wire microphone and wireless 

microphone can be used at the same time.

5. Adjust TREBLE/BASS  to suitable level. When feed-back 

comes from amplifier, please reduce TREBLE. If feedback 

still exists, reduce the volume slightly.

6. REC OUT can connect to recorder player or external 

amplifier.

1. Connect amplifier to AC power, charge indicator will light. 

The unit starts to charge rechargeable battery. DC power 

can not charge the battery.

2. During charging you can use the unit at the same time.

3. When using rechargeable battery, if  the unit stops 

producing sound,  this means the rechargeable battery 

power is low. Connect AC power to charge the battery. 

Charging time is about 8~10 hours. 

4. Please charge this device every 2 months if  you don't use 

the device for a long period of time.

5. Unplug th unit from mains power supply if you are not 

going to  use this device for a long time or after charging.

-3-

-4-