DLS Svenska AB DLS CA12 Manuel D’Utilisation

How to install and

operate the

500 Watts

mono amplifier

This owners manual is written in easy english and
uses a lot of drawings to simply the installation and
use of the above amplifier.

Your DLS amplifier must be installed correctly in or-
der to work well. This manual will show you how to
install the amplifier like a pro. Please read the entire
manual before beginning the  installation.
Install the amplifier yourself if you feel confident  with
our instructions and if you have the proper tools.
However if you feel unsure, turn over the installation
job to someone better suited to it.

Warranty Service

This amplifier  is covered by warranty, depending on
the conditions in the country where it is sold. If the
amplifier is returned for service, please include the
original dated receipt with the product.

 

 

 

 

 

 Technical Assistance

For technical assistance ask the shop where the
product was sold or the distributor in your very coun-
try.
You can always phone the DLS Helpdesk in Sweden
+ 46 31 84 00 60 or send an e-mail to info@dls.se.
Information can also be found on our WEB-site
www.dls.se

Specifications................................

1

Features……………………………..

2

Installation…………………….…….

2

Trouble-shooting……………………

2

Tools and materials needed……….

3

Amplifier installation kit…………....

3

Routing Wires……………………....

3

Wiring
Power and Outputs……………..….

4

Inputs and controls………………...

5

Input level control..........................

5

Crossovers…………......................

5

Phase control.....………………...…

6

Speaker wiring.............………….….

6

Testing..........................................

6

Professional tips……………………..

7

Number of channels

1

Power output:
R.M.S. output in 4 ohm (0,1% THD)

1 x 220 W

R.M.S. output in  2 ohm (0,4% THD)

1 x 400 W

R.M.S. output  in 1 ohm (0,5% THD)

1 x 500 W

All above output power ratings at 13,8 Volt
Signal to noise ratio, A-weighted

>100 dB

Damping factor

>100

Frequency response

10 Hz - 35 kHz

Input impedance, low level

10 kohm

Input impedance, high level

100 ohm

Input  sensitivity

0,25 - 5V

RCA output

yes

Phase control 0-180 degrees variable yes
Filter subsonic

15 - 150 Hz

Filter lowpass 12/24 dB slope

50 - 500 Hz

Power consumption, idle

0,8 A

Maximum current draw

80 A

Built-in fan cooling in bottom plate

yes

Fuse

2 x 30A

Dimensions (mm)

67x295x250

Dimensions (inch)

2,63x11,6x9,84

Weight

3,8 kg (8,4 lb)

We follow a policy of continuous advancement in
development. For this reason all or part of specifications
& designs may be changed without prior notice.

Approval of electromagnetic compatability according
to the EEC Directive 95/54/EC

 E 13

    Approval No: 022495