TIC WRS010 Manuel D’Utilisation

 

11

 

Troubleshooting…  

No Sound? 

 

Transmitter is not initialized – Re-check the 
power is “on” at the transmitter and try changing 
“channels at the transmitter. 

 

Check the audio signal source both to and from 
the transmitter. Try another cable to ensure 
integrity. 

 

Check the receiver amplifier, if used, is powered 
“on” at the mains, is not on “mute”, has no 
headphones attached and that the Channels 
used for the transmitter/ exterior speakers 
(usually A or B) is in operation. 

 

Refer to the owners guide that came with your 
receiver amplifier. 

 

Check the “on” switch at the Remote Control to 
make sure the speaker is switched “on”. 

 

Check the volume control on your Remote 
Control is switched high enough for volume to 
be heard. 

 

Check the “Green” indicator light on your 
speakers to ensure they are receiving a signal. 

 

Ensure you speakers are receiving power. Red 
LED..  

No Sound from one 
speaker 

 

Check the “balance” control on your receiver 
amplifier is “equal”. 

 

Check all connections and cable to and from, or 
the integrity of the transmitter source to the 
inoperable speaker. 

 

Check the batteries or power source(s) to the 
inoperable speaker. 

 

Speaker has 
intermittent or rough 
sound; the distance 
of the remote 
control volume 
controller becomes 
nearer 

 

 

Loudspeaker is flashing red or full light – the 
battery of the loudspeaker or remote control will 
soon be out of power. Please replace. 

 

Check the “range” by temporarily bringing the 
exterior speakers closer to the transmitter 
source. 

 

Lift the transmitter height to see if this has any 
effect. 

One speaker 
sounds distorted, 
lower volume   

 

Follow same procedure as above for “No 
Sound”