Turbosound 50T Manuel D’Utilisation

If either of the drive units in your IMPACT 50 cabinet should cease functioning 
and need a replacement, you are advised to remove the faulty unit from the 
cabinet and send it to a professional service centre authorised to recone and 
repair Turbosound loudspeakers. 

1.

 

The loudspeaker grille is held in place by four plastic push rivets. These are 
removed by placing a small flat blade screwdriver under the flange and 
carefully lifting upwards. Set the grille aside for later re–assembly. Spare 
rivets are supplied in the accessory pack with your product for re–fitting the 
loudspeaker grille. 

2.

 

Undo the four screws holding the driver in place and carefully lift it out and 
away from the cabinet. Make a note of the driver polarity for later 
reconnection. Disconnect the cables from the drive unit and completely 
remove the driver from the cabinet.  

3.

 

To reinstate the driver simply reverse the above procedure, making sure you 
observe the correct polarity when reconnecting the cables back into the 
terminals of the drive units. 

1.

 

Remove the loudspeaker grille as described above and set the grille aside 
for later re–fitting. 

2.

 

Undo the four screws holding the high frequency tweeter in place, and 
carefully lift it out and away from the cabinet. Make a note of the driver 
polarity for later reconnection. Disconnect the cables from the drive unit and 
completely remove the driver from the cabinet.  

3.

 

To reinstate the high frequency tweeter, simply reverse the above procedure 
making sure you observe the correct polarity when reconnecting the cables 
back into the terminals of the drive unit.