Turbosound TCS-122 Manuel D’Utilisation

 

As with all rigging, the flying of these arrays should only be carried out by a professional rigger.  
The Turbosound rigging system has been designed and constructed to a high standard of safety, and 
tested to the most demanding of specifications. In order to ensure the highest safety standards, this 
information on the assembly and safe use of rigging accessories must be understood and followed.  
Only use Turbosound recommended rigging accessories, which are specifically designed for their 
intended purpose. Do not use Turbosound rigging with other types or brands of loudspeakers. This 
practice may compromise safety standards and Turbosound will not be responsible for damage or 
injury so caused. Do not modify the rigging accessories, or use them in a way other than that 
described in this user manual. Rigging components supplied as part of a complete assembly are non-
interchangeable and must not be exchanged with the component parts of any other assembly. The 
component parts of a Turbosound rigging accessory must only be assembled using the fasteners and 
methods of assembly recommended in this guide. The use of fasteners and methods of assembly not 
specified or approved by Turbosound may result in an unsafe rigging assembly. Welding, or any 
other means of permanently fixing rigging components to each other or to cabinet fixing points is not 
allowed. Rigging assemblies must only be assembled using the appropriate parts and fixings as 
specified in this manual using the specific mounting instructions. Rigging components or assemblies 
must only be fixed to Turbosound loudspeaker cabinets using the cabinet fixing points, assembly 
methods and fasteners specified in this guide and the specific mounting instructions. When 
assembling the loudspeaker array ensure that all fixings are securely tightened before lifting the 
array. 

All loudspeaker clusters flown in theatres, studios or other places of work and entertainment must, in 
addition to the principle load bearing means of suspension, be provided with an independent, and 
properly rated and securely attached secondary safety. Only steel wire ropes or steel chains of an 
approved construction and load rating may be used as secondary safeties. 

Carefully inspect rigging systems components and cabinets for defects or signs of damage before 
proceeding to assemble a flown array. If any parts are damaged or suspect, DO NOT USE THEM. 
Regular, more rigorous test and inspection of rigging components must also be carried out. Safety 
legislation and test and inspection requirements will vary from country to country. In most cases, 
annual independent test and inspection by a suitably approved and qualified inspector will be 
required. Users must ensure compliance with all applicable safety requirements. Turbosound 
recommends regular safety inspections and further recommends that a logbook be kept detailing the 
test and inspection history of each Turbosound rigging accessory. Always wear protective headwear, 
footwear and eye protection in accordance with local regulations. Anyone involved in flying ANY 
sound system should take note of the following advice: 
The rigging of a flown sound system may be dangerous unless undertaken by qualified personnel 
with the required experience and certification to perform the necessary tasks. Fixing of hanging 
points in a roof should always be carried out by a professional rigger and in accordance with the local 
rules of the venue. The house rigger and/or building manager must always be consulted.