RBH Sound 1001RB Manuel D’Utilisation
6
1001RB Series
Sound Tips
The1001RB Series has several unique features which, if
used properly, will obtain that sound you have been
searching for.
used properly, will obtain that sound you have been
searching for.
The Equalizer:
The Equalizer is used to fine tune your sound. When
adjusting it, do it just a little at a time. These are active
circuits, and small changes can make a big difference in
your sound. With a little experimentation you will find
that this equalizer is very easy to use, never sounds weird
and provides you with a large variety of great sounds,
unique to GK.
adjusting it, do it just a little at a time. These are active
circuits, and small changes can make a big difference in
your sound. With a little experimentation you will find
that this equalizer is very easy to use, never sounds weird
and provides you with a large variety of great sounds,
unique to GK.
Contour:
Increasing the Contour level will scoop out mid-range
frequencies while boosting the highs and lows. The
sound, once again, is unique to GK and unavailable on
any other Bass amp.
frequencies while boosting the highs and lows. The
sound, once again, is unique to GK and unavailable on
any other Bass amp.
String Bass:
The way a Bass amp deals with the instrument low string
is a critical part of its sound. In fact, a five string
instrument requires an entirely different low end re-
sponse than a four string instrument. No equalizer can
make the necessary adjustments to accommodate both.
However, the String Bass button on the 1001RB Series does
just that. When it is out, the 1001RB is voiced like the
800RB (the world’s classic four string amp). Push it
in and the 1001RB is voiced for five string instruments.
For some playing styles you may want it in, even with a
four string instrument.
is a critical part of its sound. In fact, a five string
instrument requires an entirely different low end re-
sponse than a four string instrument. No equalizer can
make the necessary adjustments to accommodate both.
However, the String Bass button on the 1001RB Series does
just that. When it is out, the 1001RB is voiced like the
800RB (the world’s classic four string amp). Push it
in and the 1001RB is voiced for five string instruments.
For some playing styles you may want it in, even with a
four string instrument.
Sound
Tips
Boost/Master:
Turning up the Boost control, will add a little growl to
your tone. This is an unmistakable GK trade mark
sound, that you will grow to appreciate. Raising the
Boost while lowering the Master will add more growl
while keeping the sound level the same. Growl is
actually a small amount of even order harmonic distor-
tion, that sounds great through a woofer, but horrible
through a horn (see Bi-Amp solution below). For
most playing situations, the Master is set between 12 &
3 o’clock. The cleanest sound is obtained by setting
the Master above 12 o’clock, and going above 3
o’clock for maximum power situations.
your tone. This is an unmistakable GK trade mark
sound, that you will grow to appreciate. Raising the
Boost while lowering the Master will add more growl
while keeping the sound level the same. Growl is
actually a small amount of even order harmonic distor-
tion, that sounds great through a woofer, but horrible
through a horn (see Bi-Amp solution below). For
most playing situations, the Master is set between 12 &
3 o’clock. The cleanest sound is obtained by setting
the Master above 12 o’clock, and going above 3
o’clock for maximum power situations.
Direct Out:
The 1001RB provides a low noise, high quality balanced
direct out for connection to PA and recording consoles.
With the Pre/Post EQ switch set to “Pre” (Out), the direct
output signal is fed directly from our low noise, high
headroom, FET input stage providing a low noise output
superior to external direct boxes and impedance trans-
formers. In addition, this output is calibrated for 1.0V (0
dBV) output and can be adjusted to unity gain (instru-
ment level) by adjusting the Level control to -15 dB (U) .
With the switch in the Pre position, the Direct Output
signal is only effected by the Level, -10dB Pad, and Tuning
Mute controls. This allows you to adjust your tone and
volume on stage without changing the Direct Output
signal level and confusing your sound man.
direct out for connection to PA and recording consoles.
With the Pre/Post EQ switch set to “Pre” (Out), the direct
output signal is fed directly from our low noise, high
headroom, FET input stage providing a low noise output
superior to external direct boxes and impedance trans-
formers. In addition, this output is calibrated for 1.0V (0
dBV) output and can be adjusted to unity gain (instru-
ment level) by adjusting the Level control to -15 dB (U) .
With the switch in the Pre position, the Direct Output
signal is only effected by the Level, -10dB Pad, and Tuning
Mute controls. This allows you to adjust your tone and
volume on stage without changing the Direct Output
signal level and confusing your sound man.
Changing the Pre/Post EQ switch to “Post” ( In),
sends the “GK sound” and preamp response to the
Direct Out jack. This gives you complete control over
the Direct Out’s tone and volume. In addition, a
Ground (Gnd) Lift switch is included to remove hum
and buzz when connecting to equipment powered by
a different ground system.
sends the “GK sound” and preamp response to the
Direct Out jack. This gives you complete control over
the Direct Out’s tone and volume. In addition, a
Ground (Gnd) Lift switch is included to remove hum
and buzz when connecting to equipment powered by
a different ground system.