Yamaha TX-761DAB Manuel D’Utilisation

Connect the supplied indoor DAB antenna to the DAB 
antenna terminal on the rear panel and attach the indoor 
DAB antenna vertically on the wall.

y

It is recommended that you use the tuning aid function (see 
page 14) when you set up the indoor DAB antenna in order to 
maximize DAB reception capability. After the automatic 
scanning operation (see page 11), use “Signal Q” display to check 
the signal quality of the currently received DAB service (see 
page 18).

• Be sure to check the DAB coverage in your area in that not all 

areas are currently being covered. For a list of nationwide DAB 
statuses and worldwide DAB frequencies, check WorldDAB 
online at “http://www.worlddab.org/”.

• If the DAB signal is weak, use a commercially available 

outdoor DAB antenna for better reception.

Both FM and AM indoor antennas are supplied with this 
unit. In general, these antennas should provide sufficient 
signal strength. Connect each antenna correctly to the 
designated terminals.

• The AM loop antenna should be placed away from this unit.
• A properly installed outdoor antenna provides clearer reception 

than an indoor one. If you experience poor reception quality, 
install an outdoor antenna. Consult the nearest authorized 

Yamaha

 dealer or service center about outdoor antennas.

• The AM loop antenna should always be connected, even if an 

outdoor AM antenna is connected to this unit.

• The wire of the AM loop antenna does not have any polarity.

■ Assembling the supplied AM loop 

■ Connecting the wire of the AM loop 

For maximum safety and minimum 
interference, connect the antenna GND 
terminal to a good earth ground. A good earth 
ground is a metal stake driven into moist earth.

Use a 5 to 10 m of vinyl-
covered wire extended 
outdoors from a window.