Yamaha TX-761DAB Manuel D’Utilisation

Before tuning into DAB services, you must perform the 
automatic scanning.

BAND on the front panel (or remote 

control) repeatedly to select DAB as the 
reception band.
The DAB indicator lights up in the front panel display, and 
then “DAB initialize” appears in the front panel display.

When you select DAB as the reception band for the first 
time, the following message appears for 2 second.

This unit starts scanning for DAB services in the area and 
add them to the channel list as they are found.

The number of channels found is displayed. The number is 
updates when new channels are found.

Once the scanning is complete, this unit is tuned into the 
DAB service of the DAB service registry list.

y

When you have already performed the automatic scanning before 
you set this unit to the DAB tuning mode for the first time, “DAB 
initialize” does not appear in the front panel display. See step 2 on 
page 12, and proceed with the DAB tuning operation.

■ Using the automatic scanning function

Use the automatic scanning function to scan the DAB 
service again. This feature is useful when you want to 
register new DAB services or you want to register the 
DAB services broadcast in another location.

You can select the scanning frequency range as follows.

Full range scanning
This unit scans the entire range of Band III and L Band 
(see page 18).

AUTO SCAN on the front panel 

(or remote control) for 3 seconds.
This unit starts the full range scanning. “Autoscan Full” 
appears in the front panel display.
Once this unit has finished scanning, this unit is tuned into 
the first DAB station in the DAB service registry list.

Local range scanning
This unit scans the limited range of Band III.

AUTO SCAN on the front panel (or remote 

control) briefly.
This unit starts the local range scanning. “Autoscan 
Local” appears in the front panel display.
Once this unit has finished scanning, this unit is tuned into 
the first DAB station in the DAB service registry list.

If this unit cannot detect a DAB service in the DAB service 
registry list when this unit performs the automatic scanning 
operation, this unit deletes the service.

DAB initialize
Please wait

Autoscan Full

0

>

Autoscan Full 10
>>>>>>>>>>>

If the automatic scanning operation is not 
successful...
“No stations Available” and then following display 
appears in the front panel display.

Rotate PRESET/TUNING (or press SELECT 
repeatedly) to select “Tune aid” or “Autoscan”.
• Select “Tune aid” to check the signal strength of the 

DAB channel that is broadcast from the nearest 
station (see page 14).

• Select “Autoscan” to carry out the automatic 

scanning operation again.

For further details about problems and their remedies, 
refer to the “Tuner” section in “Troubleshooting” on 
page 25.

< > or select

pTune aid

[