Yamaha YDP2006 Manuel D’Utilisation

 

YDP2006

 

1.

 

This product, when installed as indicated in the instructions 
contained in this manual, meets FCC requirements. 
Modifications not expressly approved by Yamaha may void your 
authority, granted by the FCC, to use the product.

2.

 

 When connecting this product to accessories 

and/or another product use only high quality shielded cables. 
Cable/s supplied with this product MUST be used. Follow all 
installation instructions. Failure to follow instructions could void 
your FCC authorization to use this product in the USA.

3.

 

 This product has been tested and found to comply with 

the requirements listed in FCC Regulations, Part 15 for Class 
“B” digital devices. Compliance with these requirements 
provides a reasonable level of assurance that your use of this 
product in a residential environment will not result in harmful 
interference with other electronic devices. This equipment 
generates/uses radio frequencies and, if not installed and used 
according to the instructions found in the users manual, may 
cause interference harmful to the operation of other electronic 
devices. Compliance with FCC regulations does not guarantee 
that interference will not occur in all installations. If this product 
is found to be the source of interference, which can be 
determined by turning the unit “OFF” and “ON”, please try to 
eliminate the problem by using one of the following measures:

Relocate either this product or the device that is being affected 
by the interference.

Utilize power outlets that are on different branch (circuit breaker 
or fuse) circuits or install AC line filter/s.

In the case of radio or TV interference, relocate/reorient the 
antenna. If the antenna lead-in is 300 ohm ribbon lead, change 
the lead-in to co-axial type cable.

If these corrective measures do not produce satisfactory 
results, please contact the local retailer authorized to distribute 
this type of product. If you can not locate the appropriate 
retailer, please contact Yamaha Corporation of America, 
Electronic Service Division, 6600 Orangethorpe Ave, Buena 
Park, CA 90620

*This applies only to products distributed by YAMAHA CORPORATION 

OF AMERICA

 

This digital apparatus does not exceed the “Class B” limits for 
radio noise emissions from digital apparatus set out in the Radio 
Interference Regulation of the Canadian Department of 
Communications.

Le présent appareil numérique n’émet pas de bruits radio-
électriques dépassant les limites applicables aux appareils 
numériques de la “Classe B” prescrites dans le Règlement sur le 
brouillage radioélectrique édicté par le Ministère Des 
Communications du Canada.

*This applies only to products distributed by YAMAHA CANADA 
MUSIC LTD.

 

The wires in this mains lead are coloured in accor-

dance with the following code:

 

GREEN-AND-YELLOW : EARTH
BLUE : NEUTRAL
BROWN : LIVE

 

As the colours of the wires in the mains lead of this apparatus may 
not correspond with the coloured markings identifying the 
terminals in your plug, proceed as follows:

The wire which is coloured GREEN-AND-YELLOW must be 
connected to the terminal in the plug which is marked by the letter 
E or by the safety earth symbol   or coloured GREEN or 
GREEN-AND-YELLOW.

The wire which is coloured BLUE must be connected to the 
terminal which is marked with the letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the 
terminal which is marked with the letter L or coloured RED.