Yamaha RX-V1400 Manuel D’Utilisation

Recording adjustments and other operations are 
performed from the recording components. Refer to the 
operation instructions for those components.

• Do a test recording before you start an actual recording.
• When this unit is set in the standby mode, you cannot record 

between other components connected to this unit.

• The setting of TONE CONTROL, VOLUME, “Speaker level” 

(page 50) and programs does not affect the recorded material.

• A source connected to the MULTI CH INPUT jacks of this unit 

cannot be recorded.

• S-video and composite video signals pass independently 

through this unit’s video circuits. Therefore, when recording or 
dubbing video signals, if your video source component is 
connected to provide only an S-video (or only a composite 
video) signal, you can record only an S-video (or only a 
composite video) signal to your VCR.

• A given input source is not output on the same REC OUT 

channel. (For example, the signal input from VCR 1 IN is not 
output on VCR 1 OUT.)

• Check the copyright laws in your country to record from 

records, CDs, radio, etc. Recording of copyrighted material may 
infringe copyright laws.

■

The DTS signal is a digital bit stream. Attempting to 
digitally record the DTS bit stream will result in noise 
being recorded. Therefore, if you want to use this unit to 
record sources that have DTS signals recorded on them, 
the following considerations and adjustments need to be 
made.
For LDs, DVDs and CDs encoded with DTS, when your 
player is compatible with the DTS format, follow its 
operation instruction to make a setting so that the analog 
signal will be output from the player.

If you playback a video source that uses scrambled or 
encoded signals to prevent it from being dubbed, the 
picture itself may be disturbed due to those signals.

00_RX-V1400U_EN.book  Page 40  Thursday, February 19, 2004  4:26 PM