Bel Canto Design DAC3.5VB Manuel D’Utilisation
Fuse replacement:
This appliance is fitted with a non-rewireable 10 amp
mains plug. The plug contains a 10 amp fuse. If the fuse
has blown it can be replaced as follows:
a) Pull out the black fuse cover/carrier.
b) Remove and dispose of the blown fuse.
c) Fit a new 10 amp BS1362 approved fuse into the carrier
and push the carrier back into the plug.
This appliance is fitted with a non-rewireable 10 amp
mains plug. The plug contains a 10 amp fuse. If the fuse
has blown it can be replaced as follows:
a) Pull out the black fuse cover/carrier.
b) Remove and dispose of the blown fuse.
c) Fit a new 10 amp BS1362 approved fuse into the carrier
and push the carrier back into the plug.
Always ensure the fuse cover is fitted. If the fuse cover is
missing do not use the plug. Contact your Bel Canto
retailer to obtain a replacement fuse cover. Fuses are for
fire protection and do not protect against electric shock.
WARNING: THIS APPLIANCE MUST BE
GROUNDED.
Bel Canto Design Ltd. declare that this product is in conformance
with the Low Voltage Directive 73/23/EEC and Electromagnetic
Compatibility 89/336/EEC as amended by 92/31/EEC and
93/68/EEC.
The conformity of the designated product with the provisions of
Directive number 73/23/EEC (LVD) is proved by full compliance
with the following standards:
EN60065 2002 General requirements
with the Low Voltage Directive 73/23/EEC and Electromagnetic
Compatibility 89/336/EEC as amended by 92/31/EEC and
93/68/EEC.
The conformity of the designated product with the provisions of
Directive number 73/23/EEC (LVD) is proved by full compliance
with the following standards:
EN60065 2002 General requirements
The conformity of the designated product with the provisions of
Directive number 89/336/EEC (EMC) is proved by full compliance
with the following standards:
EN55013 2001 Conducted emissions
EN55013 2001 Absorbed emissions
EN55020 2002 Immunity
Directive number 89/336/EEC (EMC) is proved by full compliance
with the following standards:
EN55013 2001 Conducted emissions
EN55013 2001 Absorbed emissions
EN55020 2002 Immunity
The conformity of the designated product with the provisions of
Directive number 2005/32/EC ecodesign requirements is proved
by full compliance with the ‘off mode’ setting power of 0.0 Watts.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and
receiver.
receiver.
•
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
technician for help.