JVC FS-S57 Manuel D’Utilisation
9
Basic and Common Operations
Setting the Clock
Before operating the unit any further, first set the unit’s clock.
When you plug in the power cord, “AM 12:00” starts flashing
on the display.
You can set the clock when the unit is either turned on or in
standby mode.
When you plug in the power cord, “AM 12:00” starts flashing
on the display.
You can set the clock when the unit is either turned on or in
standby mode.
On the remote control ONLY:
1
Press CLOCK/TIMER.
The hour digits start flashing on the display.
2
Press
UP or DOWN to adjust
the hour, then press CLOCK/
TIMER.
TIMER.
The minute digits start flashing.
• When you press and hold
• When you press and hold
UP or
DOWN, the hour digit changes
continuously.
continuously.
3
Press
UP or DOWN to adjust the
minute, then press CLOCK/TIMER.
The built-in clock starts.
• When you unplug the power cord or if a power failure occurs
The clock is reset to “AM 12:00” right away. If this happens, set
the clock again.
the clock again.
• The clock may gain or lose 1 to 2 minutes per month
If this happens, reset the clock.
CLOCK/
TIMER
CLOCK/
TIMER
DISPLAY
DISPLAY
UP
DOWN
To show the clock when the unit is turned on
On the remote control ONLY:
Press DISPLAY.
The clock indication appears on the display.
The clock indication appears on the display.
To return to the normal display, press DISPLAY
again.
again.
When playing an MP3 disc
Pressing DISPLAY shows the elapsed playing time instead of the
clock time.
clock time.
To change the clock
1
Make sure the
(timer) indicator and the timer mode
indicator (
DAILY) are not lit on the display.
• If they are lit, press and hold CLOCK/TIMER until they
go off.
2
Press CLOCK/TIMER repeatedly until the unit enters
the clock setting mode (the hour digits start flashing
on the display).
First time you press CLOCK/TIMER, the unit enters the
timer setting mode. (See page 20.)
the clock setting mode (the hour digits start flashing
on the display).
First time you press CLOCK/TIMER, the unit enters the
timer setting mode. (See page 20.)
3
Repeat steps 2 and 3 of the procedure “Setting the
Clock.”
Clock.”
4
Press and hold CLOCK/TIMER again so that the
(timer) indicator and the timer mode indicator
(
(timer) indicator and the timer mode indicator
(
DAILY) go off.
To turn off the clock indication (power save mode)
On the remote control ONLY:
Press DISPLAY while the unit is in standby mode.
“DISPLAY OFF” appears on the display and the
clock indication goes off.
“DISPLAY OFF” appears on the display and the
clock indication goes off.
To turn on the clock indication, press DISPLAY
again while the unit is in standby mode.
“DISPLAY ON” appears on the display.
again while the unit is in standby mode.
“DISPLAY ON” appears on the display.
09_12_FS_S57[J]_2.p65
04.2.16, 10:00 PM
9