ONKYO HT-RC180 Manuel D’Utilisation

46

You can specify the output resolution for the HDMI 
OUT and COMPONENT VIDEO MONITOR OUT and 
have the AV receiver upconvert the picture resolution as 
necessary to match the resolution supported by your TV.

If you connect your TV to the HDMI OUT, set the 
“Monitor Out” setting to “HDMI”, so that the 
onscreen setup menus are displayed and composite 
video, S-Video, and component video sources are 
upconverted and output by the HDMI OUT.
If you connect your TV to the COMPONENT VIDEO 
MONITOR OUT, set the “Monitor Out” setting to 
“Analog” so that the onscreen setup menus are 
displayed and composite video and S-Video sources 
are upconverted and output by the COMPONENT 
VIDEO MONITOR OUT.

Press the [RECEIVER] button, 
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make 
sure the appropriate external input is 
selected on your TV.

q]/[w] but-

tons to select “1. Input/Output 
Assign”, and then press 
[ENTER].
The “Input/Output Assign” menu 
appears.

qwer

q]/[w] but-

tons to select “1. Monitor Out”, 
and then press [ENTER].
The “Monitor Out” menu appears.

q]/[w] but-

e]/[r] 

Select this if your TV is connected 
to the COMPONENT VIDEO 
MONITOR OUT, S MONITOR 
OUT, or V MONITOR OUT.

Select this if your TV is connected 
to the HDMI OUT.

Notes:
• If not connected to HDMI OUT, the 

“Monitor Out” setting will be 
automatically switched to “Analog” 
(see page 28).

• When “HDMI” is selected, the 

onscreen setup menus are output by 
only the HDMI outputs. If you’re 
not using the HDMI outputs and 
select “HDMI” by mistake and the 
menus disappear, press the AV 
receiver’s [MONITOR OUT] 
button so that “Monitor Out: 
Analog” appears on the display.

TX-NR807_En.book  Page 46  Tuesday, July 28, 2009  12:00 PM