Philips HTS9800W Manuel D’Utilisation

51

– Press ÇSTOP button twice before selecting the system  

 

   setup  menu.
–  Depending on the disc availability, some menu items cannot  
   be  selected.

–  Insert a readable disc with the playback side facing down.    
   The DVD+R/CD-R must be fi nalised.
–  Check the disc type, colour system (PAL or NTSC) and  

 

   region  code.
–  Check for any scratches or smudges on the disc.
–  Press SYSTEM MENU to switch off the system setup menu   
   screen.
–  You may need to enter the password in order to change the
   parental control rating level or to unlock the disc for  

 

   playback.
–  Moisture may have condensed inside the system. Remove  

 

   the disc and leave the system switched on for about an hour.

–  Press the SURR. button to select a correct surround sound  
   setting.
–  Make sure the source you are playing is recorded or  

 

   broadcast in surround sound (DTS, Dolby Digital, etc.).

–  If the signal is too weak, adjust the antenna or connect an
   external antenna for better reception.
–  Increase the distance between the system and your TV or    
   VCR.
–  Tune in to the correct frequency.
–  Place the antenna further away from any equipment that  

 

   may be causing the interference.

–  Select the source (for example, SOURCE) before you
   press the function button (É, . , >).
–  Reduce the distance between the remote control and the
   DVD  system.
–  Replace the batteries with new ones.
–  Point the remote control directly toward the IR sensor.
–  Check that the batteries are loaded correctly.

–  Check that the DivX fi le is encoded in ‘Home Theatre’  

 

   mode with DivX 5.x/6.x encoder.

–  Disconnect the power cord from the power outlet for a    
   few minutes. Reconnect the power cord and try to operate  
   again as usual.

–  Press and hold the ÇSTOP button on the remote control,   
   followed by pressing number button “2”, “5” and “9”.