Emerson NR31 Manuel D’Utilisation

  • Connect the plug of the Companion speaker to the R SPEAKER OUT (external speaker) jack on the back panel of the main unit.

  • Connect the AC power cord of the main unit to your household AC outlet.

1.) Set the Power/Band selector to the FM AUTO or AM position. The POWER ON indicator light comes ‘On’.

2.) Rotate the Tuning knob to tune to the desired station. If you are in the FM AUTO mode and you tune to an FM Stereo station, the FM

STEREO indicator comes ‘On’.

3.) Adjust the VOLUME control to the desired level.

4.) When you are finished listening, set the Power/Band selector to the ‘OFF’ position. The POWER ON indicator light goes ‘Off’.

If FM reception is noisy or weak, try changing the position and direction of the FM wire antenna until you find the position that provides the
best reception.

If AM reception is unsatisfactory, try repositioning the main unit slightly until the internal AM bar antenna picks up the strongest signal.

For private listening without disturbing others connect a set of stereo headphones (not included) to the PHONES 

 jack on the back panel

of the main unit. The headphones should have a 3.5mm mini plug. The main speakers shut off automatically when headphones are connected.

To protect your hearing always set the VOLUME control to a low level before you connect the headphones. Then put the headphones on and
gradually increase the VOLUME control to a comfortable listening level.

The Auxiliary Input jack allows you to listen to external audio devices, such as a personal CD player for example, through the speakers of this
system.

Connect your external device to the AUX IN jack on the back panel of the main unit. (Connection cables are not included.) Operate your
external device as you would normally and adjust the VOLUME control of this system to the desired level.

NOTE: There are no user serviceable parts in this system. Any required service must be performed only by qualified electronics service
technicians at Emerson authorized service centers.

If the cabinets become dusty they should be wiped with a soft dust cloth only. Do not use any aerosol dusting sprays or furniture polish.

If the front panels become smudged with fingerprints they may be wiped with a soft cloth, slightly dampened with a mild soap and water
solution. Do not use any type of abrasive cleaning powders or abrasive cleaning pads, as these will scratch the finish on your system.