iHome IHM20 Fascicule

MODEL: iHM20 IB
size:  215mm x 170mm
Jan 17,08

Thank you for purchasing the iHM20. Designed to work 
exclusively with the 3rd generation iPod nano, this system 
provides portable stereo audio that fits in your pocket. Please 
read the instructions carefully before operating the unit and keep 
for future reference.

The iHM20 has a built-in rechargeable battery to power the 
speakers. When the blue power light on the unit fades or 
goes out , it’s time to recharge the battery.
To recharge the battery, connect the USB cable (included) to 
the USB port on the iHM20 and connect the other end to a 
powered USB port on your computer. A red light will appear 
while the unit charges and turn off when the unit is charged. 
This unit does not charge the nano.

1.  Snap open the clear plastic door on the unit. Carefully slide  
 

your 3rd generation iPod nano into place, lining up the  

 

headphone jack on the nano with the audio plug at the 

 

base of the unit.

2.  Turn on your iPod nano and press Play. 
3.  Close the door on the unit.
4.  Swivel the speaker housing into the open (upright) position  
 

to turn ON the iHM20. Set the desired volume on your nano.

5.  Fold back the stand arm at the bottom of the unit for 
 upright 

listening.

6.  To turn the unit OFF, swivel the speaker housing to the  
 closed 

 

position.

 

The iHM20 has a headphone jack on the bottom left of the 
speaker housing so you can listen to your 3rd gen nano privately 
even while it’s protected in the iHM20 case. Just connect 
headphones to the headphone jack and play your nano as usual. 
The iHM20 speakers are disabled when the headphone jack is 
in use.
 

•  Place the unit away from sources of direct sunlight or  
 excessive 

heat.

•  Protect your furniture when placing your unit on a natural  
 

wood and lacquered finish.

•  Clean your unit with a soft cloth moistened only with mild  
 

soap and water. Stronger cleaning agents, such as Benzine,  

 

thinner or similar materials can mar the surface.

NOTE: THIS UNIT DOES 
NOT CHARGE iPOD NANO

iHome Products, a division of SDI Technologies Inc. (hereafter referred to 
as SDI Technologies), warrants this product to be free from defects in 
workmanship and materials, under normal use and conditions, for a period 
of 90 days from the date of original purchase.
Should this product fail to function in a satisfactory manner, it is best to 
first return it to the store where it was originally purchased. Should this fail 
to resolve the matter and service still be required by reason of any defect 
or malfunction during the warranty period, SDI Technologies will repair or, 
at its discretion, replace this product without charge (except for a $7.00 
charge for handling, packing, return UPS/postage, and insurance). This 
decision is subject to verification of the defect or malfunction upon delivery 
of this product to the Factory Service Center listed below. The product 
must include proof of purchase, including date of purchase. The fee for 
service without proof of purchase is 
$15.00. Before returning this product for service, please first replace the 
batteries (if applicable) with fresh ones, as exhausted or defective batteries 
are the most common cause of problems encountered.
If service is still required:
1.  Remove the batteries (if applicable) and pack the unit in a well padded, 

heavy corrugated box.

2.  Enclose a photocopy of your sales receipt, credit card statement, or 

other proof of the date of purchase, if within the warranty period.

3.  Enclose a check or money order payable to the order of SDI Technologies, 

for the sum of $7.00 ($15.00 without proof of purchase).

4.  Send the unit prepaid and insured, to the Factory Service Center listed 

below.

Disclaimer of Warranty
NOTE: This warranty is valid only if the product is used for the purpose for 
which it was designed. It does not cover (i) products which have been 
damaged by negligence or willful actions, misuse or accident, or which 
have been modified or repaired by unauthorized persons; (ii) cracked or 
broken cabinets, or units damaged by excessive heat; (iii) damage to digital 
media players, CD’s or tape cassettes (if applicable); (iv) the cost of shipping 
this product to the Factory Service Center and its return to the owner.
This warranty is valid only in the United States of America and does not 
extend to owners of the product other than to the original purchaser. In 
no event will SDI Technologies or any of its affiliates, contractors, resellers, 
their officers, directors, shareholders, members or agents be liable to you 
or any third party for any consequential or incidental damages, any lost 
profits, actual, exemplary or punitive damages. (Some states do not allow 
limitations on implied warranties or exclusion of consequential damages, 
so these restrictions may not apply to you.) This warranty gives you specific 
legal rights, and you may also have other rights which vary from state to 
state.
Your acknowledgement and agreement to fully and completely abide by 
the above mentioned disclaimer of warranty is contractually binding to you 
upon your transfer of currency (money order, cashier's check, or credit 
card) for purchase of your SDI Technologies product.

Read before proceeding
If you have any questions regarding the operation or use of this product, please visit 
www.ihomeaudio.com to view answers to frequently asked questions.
To learn more about this and other iHome products, please visit us online at www.ihomeaudio.com 

Model iHM20

MODEL: iHM20
size:  215mm x 170mm
Jan 17, 2008

QUESTIONS? Visit www.ihomeaudio.com

Folding Stand

USB Port

Swivel Speakers

Audio connector

Headphone jack