Jensen CD1211 Manuel D’Utilisation

CD1211

9

When the unit is off, the LCD displays the time 
of day. When the unit is on, the LCD 
automatically shows the tuner or CD display, 
depending on which mode of operation is 
currently activated. 
Display Clock
During tuner or CD operation, press D (9) to 
display the time of day. After five seconds, the 
display reverts to tuner or CD display.
Set Clock
1.

To set the clock, turn the radio on in tuner 
mode (or any other mode). 

2.

Press D. The time appears on the display. 

3.

Press and hold D until the time display 
begins flashing. 

4.

While the display is flashing, press the Up 
Tuning button (14) to adjust hours and the 
“A” (AM) or “P” (PM) indication. Press the 
Down Tuning button (13) to adjust 
minutes. 

5.

After five seconds, the time will set and the 
display will return to tuner or CD display.

Use the Aux In connector (19) to connect a 
portable media device for playback through the 
vehicle sound system.

The front panel release button (10) releases the 
mechanism that holds the front panel to the 
chassis. 
Detaching the Front Panel
To detach the front panel, first press the front 
panel release button (10) to release the left side 
of the panel. Next, grasp the released side and 
pull it off the chassis. After removing the front 
panel, store it in the supplied carrying case to 
protect it from dirt and damage.

Re-attaching the Front Panel
To re-attach the front panel, make sure the 
electrical terminals on the back of the panel are 
free of dust and dirt, as debris could cause 
intermittent operation or other malfunctions. 
Position the right side of the panel in place so 

that it is correctly engaged, then lightly press 
the left side of the panel until the mechanism 
locks it into place.

The reset button (11) is located on the front of 
the chassis and can only be accessed with the 
front panel removed. The reset circuitry 
protects the microprocessor circuitry. Since 
resetting the unit will erase the time and preset 
memories, it should only be activated upon 
initial installation after all wiring is complete, or 
if there is a malfunction of any of the switches 
on the unit. In these circumstances, pressing 
the reset button will clear the system and return 
the unit to normal operation.

A light-emitting diode (LED) (12) is located on 
the chassis behind the front panel and will flash 
when the panel is removed. The flashing light 
serves as a visual warning to the would-be thief 
that the unit has been disabled by removal of 
the front panel. 

1

2

/

TUNE

CD1211

CD RECEIVER

SCAN

MONO

EQ

AUX IN

RESET