Audiovox UCD200 Manuel D’Utilisation

UCD200

3

1.

Slide the mounting sleeve off the chassis. 
If it is locked into position, use the removal 
tools (supplied) to disengage it.

2.

Check the dashboard opening size by 
sliding the mounting sleeve into it. If the 
opening is too small, carefully cut or file as 
necessary until the sleeve easily slides 
into the opening. Do not force the sleeve 
into the opening or cause it to bend or 
bow. Check for sufficient space behind the 
dashboard for the radio chassis.

3.

Locate the series of bend tabs along the 
top, bottom and sides of the mounting 
sleeve. With the sleeve fully inserted into 
the dashboard opening, bend as many of 
the tabs outward as necessary to firmly 
secure the sleeve to the dashboard.

4.

Place the radio in front of the dashboard 
opening so the wiring can be brought 
through the mounting sleeve. Follow the 
wiring diagram carefully and make certain 
all connections are secure and insulated 
with wire nuts or electrical tape. After 
completing the wiring connections, turn 
the unit on to confirm operation (vehicle 
ignition must be “on”). If the unit does not 
operate, re-check all wiring until the 
problem is corrected. 

5.

Make sure the radio is right-side up, then 
carefully slide the radio into the mounting 
sleeve until it is fully seated and the spring 
clips lock it into place.

6.

Attach one end of the perforated support 
strap (supplied) to the screw stud on the 
rear of the chassis using the hex nut 
provided. Fasten the other end of the 
perforated strap to a secure part of the 
dashboard either above or below the radio 
using the screw provided. Bend the strap 
to position it as necessary.

7.

Test the radio using the Operating Instruc-
tions that follow.

/

CD-IN