Audiovox PCR2500 Manuel D’Utilisation

PCR2500

3

Inspect the radio opening as described below to 
determine if you need an installation kit. 
1.

Use the trimplate supplied with the radio to 
cover the existing dashboard opening. If it 
completely covers the opening, you can 
install the radio without an installation kit. If 
it does not cover the opening, you will 
need an installation kit (see page 4). 

2.

Check for sufficient space behind the 
dashboard for the radio chassis.

1.

Place the radio near the dashboard so the 
wires can be led through the opening.

2.

Carefully follow the wiring diagram, secur-
ing all connections with wire nuts or elec-
trical tape.

3.

Turn the unit on to confirm operation (vehi-
cle ignition switch must be “on”). If unit 
does not operate, check all wiring until the 
problem is corrected, then turn unit off.

4.

Adjust the AM Antenna Trimmer, located 
on the right side of the chassis, for opti-
mum AM reception.
a.

Tune in a weak station around 1400 
KHz on the AM band.

b.

Using a small screwdriver, slowly 
adjust the trimmer for maximum 
output from the radio.

Ground
Connect to ground
terminal.

Accessory/Ignition
Connect to existing
radio wire or radio fuse.

3A

When replacing a fuse,
make sure the new fuse
is the correcttype (AGC)
and amperage. Using
an incorrect fuse could
damage the radio.