Audiovox P-57S Manuel D’Utilisation
![Audiovox](https://files.manualsbrain.com/attachments/02e6e93a2565f360be69f08727800aa8cc9955b9/common/fit/150/50/74ec0cdd4a2b14570bcdd59c98326a350dabe1f5ca0cc3fd043018263787/brand_logo.jpeg)
-6-
SETTING THE CLOCK
1. Turn the radio on so that the radio frequency or clock time is shown on the display panel.
2. Press and hold the Select button
2. Press and hold the Select button
3
approximately 4 seconds until the time display begins flashing.
3. While the time display is still flashing, press the Manual Up Tuning button ( + ) to adjust the hours and the Manual Down Tuning
button ( – ) to adjust the minutes to the correct time.
4. When the correct time is shown on the display panel, press the Select button
3
again to return to normal display.
DETACHING THE FRONT PANEL
ATTACHING THE FRONT PANEL
Release Button
FREQUENCY STEP SWITCH
This unit is supplied pre-set at the factory for reception of North American radio stations (10 KHz. channel spacing on AM, 200 KHz.
spacing on FM). Use in other areas of the world may require different channel spacing. A switch on the bottom of the chassis allows
selection of 9 KHz. AM/50 KHz. FM channel spacing. With the 16-pin power connector un-plugged from the socket at the rear of the
chassis, slide the switch to the appropriate position using a small screwdriver blade.
spacing on FM). Use in other areas of the world may require different channel spacing. A switch on the bottom of the chassis allows
selection of 9 KHz. AM/50 KHz. FM channel spacing. With the 16-pin power connector un-plugged from the socket at the rear of the
chassis, slide the switch to the appropriate position using a small screwdriver blade.
Engage right
side first
side first
1. Make sure the front panel is right-side-up when attaching it
to the chassis as it cannot be attached when up-side down.
2. Do not press very hard on the front panel when attaching it
to the chassis. No more than light to moderate pressure
should be needed.
should be needed.
3. When attaching the front panel, make sure the right side is
correctly engaged before pressing the left side to lock it into
position.
position.
4. When taking the front panel with you, please use the supplied
carrying case to protect the panel from dirt and damage.
Make sure there is no dust or dirt on the electrical terminals
on the back of the panel as this could cause intermittent
operation or other malfunctions.
Make sure there is no dust or dirt on the electrical terminals
on the back of the panel as this could cause intermittent
operation or other malfunctions.
NOTES ON USE OF FRONT PANEL