Audiovox UMP8015 Manuel D’Utilisation

UMP8015

3

This unit is designed to fit into a 1.5 DIN 
dashboard opening, found in many imported 
cars. The unit has threaded holes in the chassis 
side panels which may be used with the original 
factory mounting brackets of some Toyota, 
Nissan, Mitsubishi, Isuzu, Hyundai and Honda 
vehicles to mount the radio to the dashboard. 
Please consult with your local car stereo 
specialty shop for assistance on this type of 
installation.

1.

Remove the existing factory radio from the 
dashboard or center console mounting. 
Save all hardware and brackets as they 
will be used to mount the new radio.

2.

Carefully unsnap the plastic frame from 
the front of the new radio chassis. Remove 
and discard the frame.

3.

Remove the factory mounting brackets 
and hardware from the existing radio and 
attach them to the new radio.

4.

Place the radio in front of the dashboard 
opening so the wiring can be brought 
through the mounting sleeve. Follow the 
wiring diagram carefully and make certain 

all connections are secure and insulated 
with wire nuts or electrical tape. After 
completing the wiring connections, plug 
the 20-pin connector into the mating 
socket on the rear of the chassis, attach 
the front panel, and turn the unit on to 
confirm operation (vehicle ignition switch 
must be “on”). If the unit does not operate, 
re-check all wiring until the problem is 
corrected. 

5.

Mount the new radio assembly to the 
dashboard or center console using the 
reverse procedure in step 1.