Audiovox MP6512i Manuel D’Utilisation

MP6512i

3

4. Place the radio in front of the dashboard opening so the wiring can be 

brought through the mounting sleeve. Follow the wiring diagram 

carefully and make certain all connections are secure and insulated 

with wire nuts or electrical tape. See “Wiring” on page 5. After 

completing the wiring connections, turn the unit on to confirm operation 

(vehicle ignition must be on). If the unit does not operate, re-check all 

wiring until the problem is corrected. 

5. Make sure the radio is right-side up, then 

carefully slide the radio into the mounting 

sleeve until it is fully seated and the spring clips 

lock it into place. 

6. Secure the rear of the unit to the car body 

using the mounting bolt and rubber cushion.

7. Test the radio using the Operating Instructions 

that follow.

Kit Installation
If your vehicle requires the use of an installation kit to mount this radio, 

follow the instructions included with the installation kit to attach the radio to 

the mounting plate supplied with the kit.
1. Wire and test the radio as outlined in the Mounting Sleeve Installation 

instructions.

2. Install the radio/mounting plate assembly to the sub-dashboard 

according to the instructions in the installation kit.

3. Attach the support strap to the radio and dashboard as described in the 

Universal Installation instructions.

4. Replace the dashboard trim panel.
ISO Installation
This unit has threaded holes in the chassis 

side panels which may be used with the 

original factory mounting brackets of some 

vehicles to mount the radio to the 

dashboard. Please consult with your local 

car stereo shop for assistance on this type 

of installation.
1. Remove the existing factory radio 

from the dashboard or center console 

mounting. Save all hardware and 

brackets as they will be used to mount the new radio.

2. Carefully unsnap the plastic frame from the front of the new radio 

chassis. Remove and discard the frame.

3. Remove the factory mounting brackets and hardware from the existing 

radio and attach them to the new radio. Do not exceed M5 x 9 MM 

maximum screw size. Longer screws may damage components inside 

the chassis.

4. Wire the new radio to the vehicle as outlined in the Universal Installation 

instructions.

5. Mount the new radio assembly to the dashboard or center console 

using the reverse procedure of step 1.

Fuses
When replacing a fuse, make sure the new fuse is the correct type and 

amperage. Using an incorrect fuse could damage the radio.
Reconnect Battery
When wiring is complete, reconnect the battery negative terminal.