Hifionics GLX60.4 Manuel D’Utilisation
Interconnect cable checklist:
Level control checklist:
- Connect the line inputs to a Radio/CD RCA outputs or line output of the
- Refer to the section “Setting up systems after installation for best
full range primary amplifier with good quality RCA cables. A “Y” adapter
performance”
may be needed as shown in the diagram.
- Use at least 16 gauge speaker wiring. These amplifiers have dual
speaker terminals, simplifying the hookup of multiple speakers. The 2
positives are one block and the 2 negatives are one block. It does
not matter which positive or negative you select since the
amplifier sees the sum of the load.
speaker terminals, simplifying the hookup of multiple speakers. The 2
positives are one block and the 2 negatives are one block. It does
not matter which positive or negative you select since the
amplifier sees the sum of the load.
Crossover frequency control checklist:
- LOW PASS: 35Hz to 250Hz
- SUBSONIC:15 Hz to 35 Hz
- BASS EQ: 0 to 10dB
- LOW PASS: 35Hz to 250Hz
- SUBSONIC:15 Hz to 35 Hz
- BASS EQ: 0 to 10dB
Minimum final loudspeaker impedance:
- PHASE: 0 to 180 degrees
- 1 ohm.
FULL RANGE
STEREO LINE INPUT
NOT USED
Y-ADAPTOR
Note: You can use the Radio/CD designated mono line output
or a full range stereo line output. For full range stereo line output,
you will need an optional “Y-Adaptor” as shown
or a full range stereo line output. For full range stereo line output,
you will need an optional “Y-Adaptor” as shown
*
INPUT OUTPUT INPUT LEVEL
PHASE REMOTE BASS EQ SONIC LOW P
ASS
L
L
R
R
SUB
POWER
PROTECT
BALANCED
9V 0.2V 0 180 0dB 10dB 15Hz 35Hz 35Hz 250Hz
SPEAKER OUTPUT
- - + +
GND REM BA
TT+12V
POWER INPUT
FUSE
INPUT OUTPUT INPUT LEVEL
PHASE REMOTE BASS EQ SONIC LOW P
ASS
L
L
R
R
SUB
POWER
PROTECT
BALANCED
9V 0.2V 0 180 0dB 10dB 15Hz 35Hz 35Hz 250Hz
SPEAKER OUTPUT
- - + +
GND REM BA
TT+12V
POWER INPUT
FUSE
HFR -
3
MI
N MAXX
BOOST
5
GLX1000.1D / GLX1400.1D / GLX1800.1D MONO AMPLIFIER APPLICATIONS
Basic application
HFR -
3
MI
N MAXX
BOOST
REMOTE TURN-ON
CHASSIS GROUND
TO BATTERY +12v
VIA FUSE
VIA FUSE
PARALLEL MONO
SUBWOOFERS
2-OHMS SVC EACH MINIMUM,
or 4-OHMS DVC EACH MINIMUM
MONO
SUBWOOFERS
Dual Subwoofer Application
REMOTE TURN-ON
CHASSIS GROUND
TO BATTERY +12v
VIA FUSE
VIA FUSE
MONO
SUBWOOFER
1-OHM MINIMUM
DESIGNATED
MONO LINE INPUT
*
DESIGNATED
MONO LINE INPUT
*