Audiovox CNP2000UC Manuel D’Utilisation

Page de 42
5
Installation Basics/Installation Planning/Cable Routing
  2.  If the vehicle has roof racks or skid ribs, it may be necessary to mount    
   
the antenna off-center.
  3.  If the vehicle roof does not provide sufficient metal surface area then    
   
the antenna can be mounted on the metal trunk lid at least 4” from the  
   
rear window.
   Caution:   DO  NOT  INSTALL  ANTENNA  INSIDE VEHICLE  PASSENGER 
COMPARTMENT. Mounting the antenna in the passenger com-
partment either on the front dash board or on the rear window 
deck area of the vehicle may interfere with reception and must 
be avoided.
   Caution:  Mounting the antenna on a non-metallic surface will also re-   
   
 
 
sult in severe degradation in reception.
  4.  If an appropriate antenna mounting location cannot be identified,  
 
   
contact your local distributor installation department for additional  
 
   
guidance.
Cable Routing
  1.  Once you have mounted the antenna in the correct location, plan how   
   
to route the cable from this location to the receiver, avoiding blocked    
   
passages and any obstructions that could kink, crimp, twist or chafe    
   
the cable. If the cable will come in contact with a rough metal opening,  
   
use a rubber grommet to prevent damage.