Motorola DSR-6400 Manuel D’Utilisation
DSR-6400 Series
37
Sat Field
Default: ---
If the Mode field is set to Manual, use this field to select a satellite name for the designated port.
This field is not editable when the Mode field is set to Auto. Press the4 button until the cursor is
This field is not editable when the Mode field is set to Auto. Press the4 button until the cursor is
at the Sat label. Press ENTER to move into the field.
If the unit has locked to a signal (check the front-panel SIGNAL LED), the unit will download the
satellite name(s) used by the provider. Leaving the blinking cursor on the up/down symbol ( )
left of the field, use the buttons to reveal the downloaded satellite name(s). Press ENTER to
satellite name(s) used by the provider. Leaving the blinking cursor on the up/down symbol ( )
left of the field, use the buttons to reveal the downloaded satellite name(s). Press ENTER to
select one and exit the field.
If the unit is not locked to a signal and the provider has instructed specific port programming, use the
4 buttons to select the character position to be changed. Then use the buttons to scroll
4 buttons to select the character position to be changed. Then use the buttons to scroll
through the character choices and press ENTER to confirm selection and exit the field.
This field displays dashes (---) when the port is not related to a satellite.
Polar Field
Default: ---
If the Mode field is set to Manual, use this field to select a polarity for the designated port. Press the 4
button until the cursor is at the Polar label. Press ENTER to move into the field and press the
buttons to display the options: H/LHP (Horizontal/Left-Hand Polarity) or V/RHP (Vertical/Right-
Hand Polarity). Select a polarity and press ENTER button to confirm the selection and exit the field.
Hand Polarity). Select a polarity and press ENTER button to confirm the selection and exit the field.
Port Config Menu
Use this menu to configure Low Noise Block (LNB) power for RF In Port 1. This menus is not
available when the Input field is set to either ASI In or GigE In.
available when the Input field is set to either ASI In or GigE In.
Port
1 Power Field
Default: OFF
Use this field to direct power to the external Low Noise Block (LNB). Press the 4 button until the
cursor is at the Port 1 Power label, and press ENTER to move into the field. Press the buttons to
display the options: OFF and ON. When the ON option is selected, the unit supplies 16-22 VDC on the
RF In Port 1 antenna input connector, as shown in Figure 2-2 on page 18.
RF In Port 1 antenna input connector, as shown in Figure 2-2 on page 18.
E Off
PORT CONFIG Port 1 Power