Novatel GM-14915095 Manuel D’Utilisation
1
OEM6
®
Family
GM-14915095
Rev 7
January 2015
QUICK START GUIDE
This guide provides the basic information needed to set up and begin using a NovAtel
®
OEM6
®
family
card.
USER MANUALS
•
For more information on the installation and operation of the NovAtel receiver, download
the
the
(OM-20000128).
•
For information on the logs and commands used to configure the NovAtel receiver,
download the
download the
(OM-20000129).
Both manuals are available from:
BOX CONTENTS
•
OEM6 receiver card and Quick Start Guide
Additional Equipment Required
For the receiver to perform optimally, the following additional equipment is required.
•
The receiver card power supply is dependent on the card purchased. Refer to the
(OM-20000128) Technical Specification sections for
OEM615, OEM617, OEM617D, OEM628 and OEM638 power requirements
•
An enclosure to protect against environmental conditions and RF interference
•
A wiring harness to provide power to the receiver and access to serial, GPIO, PPS, Event, USB,
CAN, Ethernet and other signals
CAN, Ethernet and other signals
•
A serial, USB or Ethernet cable
•
A high quality GNSS antenna or antennas (model dependent), such as NovAtel’s GPS-703-GGG
(refer to
(refer to
for options)
•
A 50 ohm antenna cable with a male MMCX (OEM617D, OEM628 and OEM638) or MCX
(OEM615 and OEM617) connector at the receiver end
(OEM615 and OEM617) connector at the receiver end
•
Microsoft Windows computer
•
ESD wrist strap
•
Optional NovAtel OEM6 Development Kit (01018849) - (
for instructions on using the OEM6 Development Kit with the OEM638 receiver card)
If a SPAN
®
GNSS+INS capable receiver was purchased, download the
(GM-14915112). If you wish to purchase SPAN firmware, contact
Sales@NovAtel.com to purchase SPAN software functionality for your receiver.