JAI TS-2030EN Manuel D’Utilisation

 

 

 

 

 

17 

 

 

 
 

 
 

 
 

 

The individual components of the system is electrically linked together as shown in Figure 1, “VIS 

elements,” on page 2. The VIS CAM 300/400 camera has connections to the J-Panel and an optional 
Flash, Night Light and Laser Vehicle Detector. The J-Panel has connection to two VIS CAM 300/400 

cameras, one Traffic Light Sensor, a 24V Power Supply, a Lane Controller, a RS485-to-ethernet 
converter for the light sensor signals, Trigger input, an optionally second J-Panel and finally a 

gigabit Ethernet switch. 

When installing the Traffic Light Sensor ensure the unit is positioned higher than either the camera 
or the flash unit so the A-side is in direct sun whenever the targeted vehicles license plates are. See 

Section 2.1 on page 6 for general site layout guidelines. 

It is extremely important the light sensor be properly positioned at the site. The light sensor must 

be placed so that no shadows from surrounding structures are cast on side A when the license plates 
being imaged by the VISCAM are in direct sunlight. 

Because sun angles at any given site can change according to time of day and time of year, it is 
important to verify that the proposed setup will function on the actual spot. 

1.  Disconnect Power 

2.  Loosen the four hex screws and remove the flange from the mounting base. See Figure 10.