Lucent Technologies 8.2 Manuel D’Utilisation
DEFINITY ECS Release 8.2
Administrator’s Guide
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
601
DS1 Circuit Pack
17
Screen 75.
DS1 Circuit Pack screen for Channel Associated Signaling
Location
This display-only field shows the port address specified in the
add
command
when the circuit pack was first administered.
Name
Use this field to assign a significant, descriptive name to the DS1 link. Lucent
recommends putting the vendor’s circuit ID for the link in this field, because that
information helps you troubleshoot problems with the link, but you could also use
this field to indicate the function or the destination of this DS1 facility. In that
case, put the DS1 link circuit ID in the Name field of the trunk group associated
with this link.
recommends putting the vendor’s circuit ID for the link in this field, because that
information helps you troubleshoot problems with the link, but you could also use
this field to indicate the function or the destination of this DS1 facility. In that
case, put the DS1 link circuit ID in the Name field of the trunk group associated
with this link.
Bit Rate
Use this field to select the maximum transmission rate for DS1 circuit packs that
support either T-1 or E-1 service. For circuit packs that only support one of these
services, the field is a display-only field.
support either T-1 or E-1 service. For circuit packs that only support one of these
services, the field is a display-only field.
NOTE:
Once an
add ds1
operation is complete (that is, the DS1 screen has been
submitted) you can’t change the Bit Rate field with a
change
ds1
command. Instead, execute a
remove ds1
command. Then use the
add ds1
command to administer the circuit pack again. You’ll have to re-enter all the
information for the circuit pack.
information for the circuit pack.
Valid entries
Usage
1–15 characters
Enter a name for the DS1 link.
add ds1 xxxxxx
Page 1 of 2
DS1 CIRCUIT PACK
Location: 01A13
Name: _______________
Bit Rate: 2.048
Line Coding: cmi
Signaling Mode: CAS
Interconnect: pbx
Country Protocol: 3
Interface Companding: mulaw
Idle Code: 11111111
MAINTENANCE PARAMETERS
Slip Detection? n