TP-LINK tlsc3130g Manuel D’Utilisation

19 

 

¾

  Reboot: Click this button to reboot this IP Camera. A confirmation dialogue will appear and 

then click OK to process. It takes two minutes to reboot this IP Camera. 

¾

  Factory Default: Click this button to reset this IP Camera to the factory default settings. A 

confirmation dialogue will appear and then click OK to process. The network LED indicator on 
the IP Camera will start to blink. This IP Camera will reboot automatically after the restoring 
has been finished

.

 Don't turn off this IP Camera during this process. 

¾

  Backup Setting: You can save configuration setting data of this IP Camera into a file. Click 

Save and follow the instructions on the browser to save this setting data file to specified 
location. 

¾

  Restore Setting:    Download the saved setting data of this IP Camera. Click Browse… and 

select the saved file. Click OK and this IP Camera is adjusted according to the loaded data 
and then restarted.   

¾

  Firmware Upgrade: Upgrade the device software. Click Browse… and select the file for 

upgrading. A confirmation dialogue will appear. Click OK to start. This IP Camera will reboot 
after upgrading has been finished. 

)

Use only upgrade files that are special for this IP Camera. Otherwise problems may occur. Don't 
turn off the IP Camera power or disconnect the network until the upgrading is completed. 

¾

  Upload Language Pack: Upgrade the device language pack. Click Browse… and select 

the file for upgrading. A confirmation dialogue will appear. Click OK to start upgrading. The 
upgrade is applied immediately. The default language is “English.”   

Click Camera to display the submenus including General, MPEG4 and MJPEG.