Pelco c3401m-a Manuel D’Utilisation

 

C3401M-A (1/06)

7

 

 If you are going to use Coaxitron protocol to communicate with the dome system, you do not have to 

set any switches. Proceed to the installation instructions that follow this section.

 

 If you are going to install a protocol translator board to communicate with the dome system through 

a non-Pelco controller, proceed to the installation instructions that follow this section. When you are instructed to install 
the translator board, you will set the switches as described in the installation/operation manual that accompanies the 
translator board.

 

 If you are going to use D or P protocol to communicate with the dome system, follow the steps below to 

1. Place the  dome drive on a flat surface with the dome liner pointing up.

2. Point the camera straight up.

3. Using a flashlight, look straight down through the viewing slot of the dome liner. Look at the circuit board in the 

bottom of the housing. Rotate the dome liner until you see two DIP switches on the circuit board.

4. Set the switches. Refer to Table A, Table B, and

 

 

The unit automatically detects D or P protocal.

 

Component Locations

 

The data port (refer to Figure 2) allows access for on-site setup and testing of the dome system. It also is used for 
uploading revised operating software and language files. Refer to 

 

 in the Operation/

Programming manual.

 

Do not remove the dome liner (refer to Figure 2). Replacing the dome liner requires qualified service 

personnel; otherwise, the dome drive may not operate properly.

SW 3

SW 2

ON

ON

REMOTE
DATA
PORT

DOME
LINER