VIVOTEK PZ7151 Manuel D’Utilisation
VIVOTEK - A Leading Provider of Multimedia Communication Solutions
6 - User's Manual
Hardware Reset
There is an indented reset button on the side panel of the Network Camera. It is used to reboot
the Network Camera or restore the Network Camera to factory default. Sometimes rebooting the
Network Camera could set the Network Camera back to normal state. If the problems remain
after rebooted, restore the Network Camera to factory default and install again.
the Network Camera or restore the Network Camera to factory default. Sometimes rebooting the
Network Camera could set the Network Camera back to normal state. If the problems remain
after rebooted, restore the Network Camera to factory default and install again.
Reboot
: Press and release the indented reset button with a needle. Wait for the Network
Camera to reboot.
Restore
: Press the indented reset button continuously for over 30 seconds until the status LED
rapidly blinks red and green simultaneously. Note that all settings will be restored to factory
default.
default.
Ext. Int.
Mic. In
12VDC
Ethernet
Ext. I/O
Ext. Int.
Audio
Out