3com FlexWATCH 3110 Manuel D’Utilisation
Network Video Server User’s Manual
Seyeon Tech Co., Ltd
68
only.
This function is not for general use. Thus, if you need more close information about this,
please contact your local distributor or manufacturer for further information,
This function is not for general use. Thus, if you need more close information about this,
please contact your local distributor or manufacturer for further information,
sales@flexwatch.com
.
2.3
Serial output device
The system supports to relay third party command to target device through Serial output
device control mode. Through this, user defined message can be reached to target device
The system supports two different modes. One is X10 protocol for PLC (Power Line
Communication) and UART(Universal Asynchronous Receiver Transmitter) device.
device control mode. Through this, user defined message can be reached to target device
The system supports two different modes. One is X10 protocol for PLC (Power Line
Communication) and UART(Universal Asynchronous Receiver Transmitter) device.
2.3.1
Serial Output Configuration
Following is guide for hardware cabling and setting.
1) Connect your Serial Output Device to RS422/485 Port or RS232 (COM or AUX)
1) Connect your Serial Output Device to RS422/485 Port or RS232 (COM or AUX)
port.
2) Go to Admin Menu >> System Configuration >> Serial Ports Configuration.
3) Select ‘Serial Output’ at COM or AUX mode, and Click ‘Apply’ button.
4) System reboot will be recommended, then click ‘Reboot’ button.
5) After rebooting, Go to Admin Menu >> System Configuration >> Serial Ports
3) Select ‘Serial Output’ at COM or AUX mode, and Click ‘Apply’ button.
4) System reboot will be recommended, then click ‘Reboot’ button.
5) After rebooting, Go to Admin Menu >> System Configuration >> Serial Ports
Configuration.
6) Click “Serial Output Mode”, then following window will show up.
- INTPLUS [2005] -