ZyXEL Communications 3.1 Manuel D’Utilisation
Chapter 6 Interfaces
ZyWALL (ZLD) CLI Reference Guide
73
6.3.2.1 Port Grouping Command Examples
The following commands add physical port 5 to representative interface ge1.
The following commands set port 1 to use auto-negotiation auto and port 2 to use a 10 Mbps
connection speed and half duplex.
connection speed and half duplex.
6.4 Virtual Interface Specific Commands
Virtual interfaces use many of the general interface commands discussed at the beginning of
. There are no additional commands for virtual interfaces.
6.4.1 Virtual Interface Command Examples
The following commands set up a virtual interface on top of Ethernet interface ge1. The virtual
interface is named ge1:1 with the following parameters: IP 1.2.3.4, subnet 255.255.255.0,
interface is named ge1:1 with the following parameters: IP 1.2.3.4, subnet 255.255.255.0,
Router# configure terminal
Router(config)# show port-grouping
No. Representative Name Port1 Port2 Port3 Port4 Port5
=========================================================
1 ge1 yes no no no no
2 ge2 no yes no no no
3 ge3 no no yes no no
4 ge4 no no no yes no
5 ge5 no no no no yes
Router(config)# port-grouping ge1
Router(config-port-grouping)# port 5
Router(config-port-grouping)# exit
Router(config)# show port-grouping
No. Representative Name Port1 Port2 Port3 Port4 Port5
=========================================================
1 ge1 yes no no no yes
2 ge2 no yes no no no
3 ge3 no no yes no no
4 ge4 no no no yes no
5 ge5 no no no no no
Router(config)# port status Port1
Router(config-port-status)# negotiation auto
Router(config-port-status)# exit
Router(config)# port status Port2
Router(config-port-status)# duplex half
Router(config-port-status)# speed 10
Router(config-port-status)# exit
Router(config)# exit