Sharp LB-1085 Manuel D’Utilisation

EZ Setup

Input Skip

Position

Language

Identification

Reset

[English]

Setup

  Press MENU to display the MENU screen, and 

then press 

 / 

 to select “Setup”.

  Press 

 / 

 to select a specific adjustment 

item, and then press ENTER.

  Press 

 / 

 (or 

 / 

) to select the desired 

setting, and then press ENTER.

  Press MENU

 to exit.

This function allows you to change the preset 
values.

Language: Select from among 4 languages (English, 

French, Spanish and German).

Monitor Location: Select “Home” or “Store” for the 

location where you plan to install the LCD Monitor.

If you select “Home”, AV MODE is set to 

• 

“STANDARD”.

If you select “Store”, AV MODE is set to  

• 

“DYNAMIC (Fixed)”.

See “Initial Setup” on page 17 for setting each item.

• 

This setting allows you to skip the HDMI or PC-IN 
Input (“Input 4”, “Input 5”, “Input 6” and “Input 7”) on 
the Input Selection operation.

 Skips the input.

 Does not skip input.

Lets you set the input terminal displayed when 
using the INPUT SOURCE menu. Press  

 / 

 / 

 / 

 to select the new name for the input 

mode.

Some input signals may have to be registered 
manually to display properly. The pair of input 
signals (resolutions) in the list below is not 
distinguishable when received. In such a case, 
you have to set the correct signal manually. After 
setting once, it will display when the same signal 
(resolution) is input again.

1024 x 768 

1360 x 768

You can only select the “Input Signal” on the Setup 

• 

menu when receiving one of the 2 input signals listed 
above.

For automatically adjusting the PC image.

Yes: Auto Sync. starts and “Now adjusting the 

image.” displays.

 This function does not work.

When Auto Sync. is successful, “Completed” displays. 

• 

If not, Auto Sync. failed.
Auto Sync. may fail even if “Completed” displays.

• 

Auto Sync. may fail if the computer image has low 

• 

resolution, has unclear (black) edges, or is moved 

while executing Auto Sync.
Be sure to connect the PC to the LCD Monitor and 

• 

switch it on before starting Auto Sync.

Ordinarily you can easily adjust the picture as 
necessary to change image position using Auto 
Sync. In some cases, however, manual adjustment 
is needed to optimize the image.

H-Pos.: Centers the image by moving it to the left or 

right.

V-Pos.: Centers the image by moving it up or down.

Clock: Adjust when the image flickers with vertical 

stripes.

Phase: Adjust when characters have low contrast or 

when the image flickers.

For resetting all Fine Sync. adjustment items to the 

• 

factory preset values, press 

 / 

 to select “Reset”, 

and then press ENTER.

It is not necessary to adjust the “Clock” or “Phase” 

• 

when a digital signal is being input, so it cannot be 
selected.
The default cursor position may not be in the center, 

• 

because the screen position variable ranges may be 
asymmetrical.
The screen position variable ranges depend on the 

• 

View Mode or the signal type.