Audiovox 1181293 Manuel D’Utilisation

 

12

7. Release video screen from locked position. Lower video screen to viewing position for access to mounting 

locations in top of video system housing. 

8. Raise video system into approximate position and connect all wiring to components. Route video cable 

through hole in mounting bracket. Connect wiring and cabling to video system per instructions included 
with video system.                          

9. Check function of all components and lights. See operating instructions for video system operations check. 

For further assistance, refer to the video system manual for the technical support phone number listed for 
your area.          

                                                                                                 
 
 
 

10.  Insert video system into opening in console. 

Note: Make sure that wires do not get 
pinched between bosses on video system and 
console. Align holes in housing with threaded 
clips in mounting bracket. Loosely install four 
(4) 6-32 X 3/4" screws (item 10 pg 2) and four 
(4) 3.5 mm washers (item 11 pg 2). Caution: 
Do not overtighten screws.  See Figure 19. 

11. Raise video screen into locked position.  

 
 
 
 
 
 

12

. 

Attach wiring to rear light (item 6 pg 2) per step 1. Install light in console and secure to plywood above 

headliner using three (3) # 8 x 2 1/2" PFH screws 
(item 2 pg 2). See Fig. 20. Tighten screws until 
rear edge of console contacts headliner. Caution: 
Do not overtighten screws or damage to vehicle 
roof may occur.  

13. Install trim ring (item 7 pg 2) around light. 
14. Attach O.E. wiring to rear A/C control head. 

Carefully snap O.E. trim ring around control head. 
Insert control head into opening and press firmly to 
engage tabs. 

 
 
 
 
 

15.  Check function of all components and lights. If  O.E. console was equipped with a Homelink



 

transmitter, refer to the vehicle owner’s manual for reprogramming instructions.