Audiovox 50-0311x-015 Series Manuel D’Utilisation

                                                                                               5

 
 
 
 
 

12. Release video screen from locked position. Lower 

video screen to viewing position for access to 
mounting locations in top of video system 
housing. 

13. Raise video system into approximate position and 

connect all wiring to components. Connect wiring 
and cabling to video system  per instructions 
included with video system. 

14. Check function of all components and lights. See 

operating instructions for video system operations 
check. For further assistance, refer  to the video 
system manual for the technical support phone 
number listed for your area. 

 

 

 

15. Insert video system into opening in console. Note: Make sure wires do not get pinched between video 

system and console. Align holes in housing with clips in mounting bracket. Secure using (4) four 6-32 x 
3/4" screws (item 2 pg 2) and  (4) four 3.5 mm washers (item 3 pg 2).  See Figure 7.                    
Caution:  Do not overtighten screws.  

  

 
 
 
 

16. Tighten screw previously installed to secure rear of 

console to headliner. Caution: Do not overtighten 
screws or damage to vehicle roof may occur. 

17. Raise video screen into locked position. 
18. Install speaker grille (item 8 pg 2). Align clips in grille 

with holes in console and press firmly.                    
See Figure 8. 

19. If speaker upgrade kit was not installed, install cover 

plate (item 9 pg 2) at front of console and secure 
using (2) two # 6 X 1/2" screws (item 5 pg 2 ). 

20. Install cover plate decal (item 10 pg ).  

 
 
 
 
                         

 

 

FIGURE 7 

FIGURE 8