Audiovox 50-0244x-019 SERIES Manuel D’Utilisation

18. Release video screen from locked position. Lower video screen to viewing position for access to

mounting locations in top of video system
housing.

19. Raise video system into approximate position

and connect all wiring to components. Route
video cable through hole in mounting bracket.
Connect wiring and cabling to video system
per instructions included with video system.

20. Check function of all components and lights.

See operating instructions for video system
operations check. For further assistance, refer
to the video system manual for the technical
support phone number listed for your area.

21. Insert video system into opening in console.

Note: Make sure that wires do not get

pinched between bosses on video system and
  console. Align holes in housing with clips in
mounting bracket. Loosely install (4) four
6-32 X 3/4" screws (item 3 pg 2) and (4) four
3.5mm washers (item 4 pg 2). Caution:
Do not overtighten screws. See Figure 13.
22. Raise video screen into locked position.

23. Through the open compartment door on

O.E.M. console, use an awl or similar tool to
align holes in console with holes in bracket.
Secure using (2) two #8 x 3/4" screws (item 2
pg 2). See Fig. 14. Close compartment door.

24. If console was equipped with a Homelink

Transmitter, refer to the vehicle owner’s
manual for reprogramming instructions.

FIGURE