Audiovox 650 Manuel D’Utilisation

                                                                                                3

   I. PREPARATION OF VEHICLE INTERIOR 

 

 

 

 
 
 

1.  Remove and retain O.E. dome light by gently 

prying downward on rear edge of lens then 
slide frame assembly out. Disconnect wiring 
and lay dome light in a safe place. See Fig. 1. 

 
 
 
 
 

 
 
 

2.  Using the front edge of dome light opening as a 

reference location, carefully measure & trim 
headliner as shown. Caution: Before cutting 
headliner material, check for  wiring or other 
componentry above headliner. Cut only where 
indicated. Make sure that the 7" cut is centered 
left to right in vehicle. See Figure 2.  DO NOT 
OVERCUT HEADLINER. 

3. Scribe a center line on the sheet metal roof of     
     the vehicle in front and rear of openings in  
     headliner. This will be used for bracket alignment.   

See Figure 2.  

 

4.  Install mounting bracket (item 6 pg. 2) with the 

bent edges upward. Slide bracket rearward until 
rear tabs engage rear O.E. roof brace. Align 
notches in bracket with center lines scribed on 
roof.  See Fig. 3 and Fig. 4. 

5.  Secure front of bracket to front roof brace using 

(2) two # 10 X 1/2" screws (item 1 pg 2). 

 

 

 

FIGURE 1 

FIGURE 2 

FIGURE 3