Echo SRM-410U Manuel D’Utilisation

Level 1.

Tools required:    200- 250 mm (8 - 10 in.) length of wire with one end   
 

 

 

bent into a hook, clean rag, funnel, and an approved    

   

fuel 

container.

Parts required:   REPOWER

TM

 Tune-Up Kit

Fuel is VERY fl ammable. Use extreme care when mixing, storing or 
handling.

1.  Use a clean rag to remove loose dirt from around fuel cap and  

empty fuel tank.

2.  Use the “fuel line hook” to pull the fuel line and fi lter from the  

tank.

3. Remove 

the 

fi lter from the line and install the new fi lter.

NOTE
Federal EPA regulations require all model year 2012 and later 
gasoline powered engines produced for sale in the United States to 
be equipped with a special low permeation fuel supply hose between 
the carburetor and fuel tank. When servicing model year 2012 and 
later equipment, only fuel supply hoses certifi ed by EPA can be used 
to replace the original equipment supply hose. Fines up to $37,500 
may be enforced for using an un-certifi ed replacement part.

Tools Required:   Spark plug wrench, feeler gauge, soft metal brush.

Parts Required:   REPOWER

TM

 Tune-Up Kit

1.  Remove spark plug and check for fouling, worn and rounded  

center electrode.

2.  Clean the plug or replace with a new one.  DO NOT sand blast to  

clean. Remaining sand will damage engine.

3.  Adjust spark plug gap by bending outer electrode.

4.  Install Spark Plug, and tighten  to 130-150 in•lbf 
 (150-170 

kgf•cm).

0.6 - 0.7 mm (.024 - .028 in)