Dolmar MS-230 C Manuel D’Utilisation

14

-  Put on the harness as shown in figure A.
-  Adjust it so that the clip is about a hand-width above your 

hipbone.

A

B

-  Correctly balancing the brushcutter reduces strain on the 

arms while working.

-  When using the trimmer head on a level terrain, the trimmer 

head should touch the ground lightly without the user having 

to hold the unit.

-  In difficult terrain or when using the steel bush cutter the

brushcutter should  balance about 0 cm above the ground 

without the user having to hold the unit.

-  Fuel the brushcutter and clip it into the harness.
-  To  balance  the  brushcutter,  loosen  the  bolt  (C/1).  Push 

the eyelet (C/2) forward to move the centre of gravity back 

towards the engine, or back to move the centre of gravity 

forward towards the tool.

-  When you are satisfied with the balance tighten the bolt

(C/1).

C

E

Starting the engine
-  Move at least 3 meters (10 feet) away from where you filled

the fuel tank.

-  Make sure you have a good footing, and lay the brushcutter 

on the ground in such a way that the cutting tool is not touch-

ing the ground or anything else.

D

-  In an emergency, pulling the red tab (D/3) will instantly detach 

the brushcutter from the operator.