Zenoah TR2002 Manuel D’Utilisation

GB-15

BC2003 / TR2002

3. Take out the spool and pull off the old line. Put one

end of new line through the spool holes and pull it
until the length is equal between each part of the line.

4. Wind up the line in the correct direction as indicated

on the spool.

5. Hook each end of the line in the slot on the edge of

the spool, and then put the ends through the eyelets
on the housing. Make sure that the spring and the
washers are in place.

6.  While holding the spool against the housing, pull the

line ends to release them from the slot.

7.  Line up the slot on the bottom cap with the hook on

the housing, press the cap against the housing until it
clicks.

1. Remove the muffler, insert a screwdriver into the vent,

and wipe away any carbon buildup. Wipe away any
carbon buildup on the muffler exhaust vent and cylin-
der exhaust port at the same time.

2. Tighten all screws, bolts, and fittings.

3. Check to see if any oil or grease has worked its way

in between the clutch lining and drum, and if it has,
wipe it away using oil-free, lead-free gasoline.

REFILLING TRIMMING LINE
1. F o r   r e p l a c e m e n t   l i n e ,   u s e   a   d i a m e t e r   o f

2.4 mm. The spool is capable for a line upto
6 m on the 4" head. Avoid using a larger line as it may
cut down the trimming performance.

2. Pinch the slotted area on the both sides of the spool

housing to unhook the bottom cap.

Aged fuel is one of major causes of engine starting failure. Before storing the unit, empty the fuel tank and run the
engine until it uses all the fuel left in the fuel line and the carburetor. Store the unit indoor taking necessary measures
for rust prevention.