Remington Power Tools 107625-02 Manuel D’Utilisation

19

Note: For additional help, visit DESA Power Tools technical service web site at 

Saw runs, but does not 
cut

Chain assembled backwards on 
guide bar

See Assembly

Saw does not cut unless 
heavily forced. Cutting 
produces only sawdust 
with few large chips

Chain is dull

See Sharpening Saw Chain

Saw runs slow. Saw stalls 
easily

Low power supply voltage

Extension cord wire size too small. See 
Extension Cords.

Motor of saw does not 
run when you squeeze 
trigger

1.  Switch lockout not pushed for-

ward in to release trigger

2.  Extension cord connections 

loose

3.  Open line fuse or circuit breaker

4.  Worn out motor brushes
5.  Open wiring circuit on saw

1.  Push switch lockout forward before 

squeezing trigger

2.  Check cord connections

3.  Check line fuse or circuit breaker

4.  See authorized service center
5.  See authorized service center

Motor of saw runs, but 
chain does not move

Gear Sprocket

Remove and inspect gear sprocket for 
damage

Chain does not get oil

All Models
1.  Clogged oil slot in guide bar
2.  Oil is too thick
Modles with Automatic Oiler
1.   Vent in oil cap clogged
2.   Filter in oil reservoir clogged

3.  Pump damaged, do not use saw

1.  Remove guide bar and clean oil slot
2.  Use correct weight of oil. See Filling 

Oil Tank

1.   Remove cap and clean vent hole
2.   Remove fi lterin oil reservoir and 
      clean
3.   See authorized service center

Chain comes off guide 
bar

1.  Chain is loose

2.  Guide bar and chain not as-

sembled correctly

1.  Tighten chain. See Saw Chain Tension 

Adjustment

2. See 

Assembly

Saw smokes

Saw damaged. Do not use saw

See authorized service center

Saw leaks oil

It is normal for oil to seep when the 
saw is not in use.

Tighten oil cap.
Note: Empty oil tank when not in use.