Husqvarna 115 149727 R01 Manuel D’Utilisation

10

ASSEMBLY

1.  Using the hacksaw, trim along the dashed line.
2.  Locate the middle chute, flat washer, hood latch,

weld nut, lock washer and machine screw from kit.

3.  Install in the appropriate hole at the upper end of 

the middle chute, according to deck size.

Trim Line

Hood Latch

Weld Nut

Machine Screw

Lock Washer

Latch Location

Flat Washer

1.  Place middle chute over the top end of the blower 

assembly.

2.  Latch middle chute to blower assembly.

 Middle Chute

Blower Assembly

Using hardware provided in kit, attach support

1. 

mount to unit.
Attach hanger bracket to support mount. Do not

2. 

fully tighten nuts at this time.

Hanger Bracket

Secure rear end of support straps to outside of 

3. 

hanger assembly. Set reinforcement plates to the 

outside of the tank brackets and fasten front end

of support strap to tank bracket and reinforcment

plate with round head bolt. Secure front end 

of reinforcement plate to tank bracket with hex

bolt. Fully secure all mounting hardware. See 

illustration. 

NOTE: Rear guard hole may need to be drilled out 

to 

5

/

16

" if kit hardware is too large.

Support Mount

Support Straps

Reinforcement Plate

Hex Bolt Placement

Round Head 

 Bolt Placement