Troy-Bilt CSV206 Manuel D’Utilisation

5

•

Remove staples, break glue on top flaps, or cut 
tape at carton end and peel along top flap to open 
carton.

•

Remove loose parts if included with unit (i.e., 
operator’s manual, etc.)

•

Cut along corners, lay carton down flat, and remove 
packing material.

•

Roll or slide unit out of carton and check carton 
thoroughly for loose parts.

Following is the list of loose parts shipped with your 
equipment. Compare the parts with the illustration in 
Figure 1 to identify these items.

1.

Nozzle

2.

Bag 

3.

Chipper Chute

4.

Tamper Plug

5.

Oil (Not Shown)

 This unit is shipped without gasoline or oil 

in the engine. Be certain to service engine with gasoline 
and oil as instructed in the accompanying engine 
manual before operating your machine.

NOTE: Reference to right or left side of the equipment
is observed from the operating position, unless
otherwise stated.

•

Before starting assembly, disconnect the spark 
plug wire from the spark plug on the chipper 
shredder vacuum and ground against the engine.

•

Remove three wing nuts from the front of the 
chipper shredder vacuum. 

•

Place nozzle in position over the three studs on unit 
and secure with wing nuts just removed.
See Figure 2.

NOTE: The metal tab on the nozzle must depress the
safety switch button attached to the front of the chipper
shredder vacuum or the engine will not start.

•

Loosen, but do not remove, the two hex bolts, flat 
washers, and flange nuts which are secured to the 
support bracket. See Figure 3. 

•

Remove the two flange nuts, hex bolts and saddle 
washers which secure the right side of the upper 
handle to the right side of the lower handle.
See Figure 4.