Troy-Bilt CS4210 Manuel D’Utilisation

10

Chute Deflector: Lubricate the pivot points on the 
chute deflector with light oil once a season.    

Engine: Refer to the Briggs & Stratton Owner/Operator 
manual packed with your unit for lubrication 
instructions.

Refer to the Maintenance section of the Briggs & 
Stratton Owner/Operator manual packed with your unit. 
Read and follow instructions carefully

•

Check engine oil level before each use as 
instructed in the separate engine manual.

•

Clean air cleaner’s precleaner every 25 hours 
under normal conditions. Clean every few hours 
under extremely dusty conditions. Replace the air 
cleaner cartridge once a season. To service the 
air cleaner, refer to the separate engine manual.

•

The spark plug should be cleaned and the gap 
reset once a season. Refer to the separate engine 
manual for correct plug type and gap specifications.

Before each use, visually inspect your chipper shredder 
for loose (or missing) nuts and bolts. Securely tighten 
(or replace) all hardware before operating the chipper 
shredder.

WARNING: The impeller’s shredder blade 
and chipper blades are sharp. Wear leather 
work gloves to protect your hands when 
cleaning out the reduction chamber.

If the reduction chamber becomes clogged with debris, 
the shredder screen can be pivoted upward so that you 
can clean the surrounding area. To do so, proceed as 
follows:

•

Stop the engine and wait until all moving parts have 
come to a complete stop.

•

Disconnect spark plug wire and keep away from 
spark plug.

WARNING: The muffler and surrounding area 
will be hot if the engine has been running. Use 
caution and protect your hands if working 
near the muffler.

•

Remove the two wing knobs on either side of the 
chute deflector and pivot the chute deflector 
upward. See Figure 8.

•

Remove the hairpin clip from the clevis pin which 
extends through the housing and shredder screen. 
See Figure 8. Retain the clevis pin and hairpin clip.

•

Pivot the shredder screen upward and clean the 
surrounding area by scraping away debris.

•

Confirm that the spark plug wire is disconnected 
and away from spark plug.

•

Pull on the starter rope two-to-three times to purge 
any remaining debris from the reduction chamber

•

When the area is cleaned, pivot the shredder 
screen downward and re-secure with the clevis pin 
and hairpin clip removed earlier.

•

Reattach the debris collection bag to the chute 
deflector, if desired.

WARNING: The impeller’s chipper blades are 
sharp. Wear leather work gloves to protect 
your hands.

•

Stop the engine and make certain the chipper 
shredder has come to a complete stop.

•

Disconnect spark plug wire and keep away from 
spark plug.

•

Pivot the shredder screen upward as instructed 
under the heading Cleaning the Reduction 
Chamber.

•

Remove the chipper chute support brace from the 
frame by removing the two hex bolts and saddle 
washers which secure it. See Figure 9.

•

Remove the chipper chute by removing three hex 
nuts and washers which secure it to the impeller 
housing. See Figure 9.

•

Rotate the impeller by hand until one of the two 
chipper blades is visible through the impeller 
housing opening.

•

Remove the blade by removing the internal hex 
screws, lock washers and hex nuts which secure it 
to the impeller. Retain the hardware.