Husqvarna 70 LP Manuel D’Utilisation
1
.
Remove components from carton
and place spreader upside down on a
padded surface. Install LH. & RH. handle
braces to frame as shown using four (4)
1/4-20 x 2 1/4” hex bolts and nuts but do
not tighten.
padded surface. Install LH. & RH. handle
braces to frame as shown using four (4)
1/4-20 x 2 1/4” hex bolts and nuts but do
not tighten.
ASSEMBLY
ASSEMBLY
ASSEMBLY
ASSEMBLY
3
.
Turn spreader upright. For ease of
assembly, make sure ON/OFF cable is on
top of handle braces. With DOT on the
handle assembly facing as shown, secure
clamp bracket using a #10 x 3/4 slotted
sheet metal screw. Install end of handle
assembly between handle braces and
secure with (2) 1/4-20 x 1 1/2” hex bolts
and nuts.
top of handle braces. With DOT on the
handle assembly facing as shown, secure
clamp bracket using a #10 x 3/4 slotted
sheet metal screw. Install end of handle
assembly between handle braces and
secure with (2) 1/4-20 x 1 1/2” hex bolts
and nuts.
2
.
Slide wheels onto end of axle with
the hub facing toward frame. Wheels are
identical to ease assembly. Align the
hole in the wheel hub and the hole in the
axle as shown. Secure drive wheel to
axle with 3/16 dia. x 2” cotter pin. Insert
1/8 dia. x 1 1/4” cotter pin in the hole
near the end of axle to retain free
turning wheel.
identical to ease assembly. Align the
hole in the wheel hub and the hole in the
axle as shown. Secure drive wheel to
axle with 3/16 dia. x 2” cotter pin. Insert
1/8 dia. x 1 1/4” cotter pin in the hole
near the end of axle to retain free
turning wheel.
DOT
RH. Handle
Brace
LH. Handle
Brace
1/4-20 x 2 1/4”
Hex Bolt
1/4-20
Hex Nut
Drive Wheel
Free Turning
Wheel
3/16 Dia x 2”
Cotter Pin
1/8 Dia x 1 1/4”
Cotter Pin
2
1/4-20
Hex Nut
1/4-20 x 1 1/2”
Hex Bolt
Hex Bolt
Handle
Assembly
ON/OFF Cable
Clamp
Bracket
#10 x 3/4
Sheet Metal
Screw