Multiquip GB12BP Manuel D’Utilisation

page 24 —gb12bw/bs/bp LIgHTINg sYsTeM • operaTIoN aNd parTs MaNuaL — rev. #0 (06/24/13)

setuP (Gb12bs)

poLe seTup (gb12bs)

1. Attach one of the clamps that come with the GBS to

the external support pole. The clamps may be attached

to vertical, horizontal, or angled pole. See Figure 27.

Figure 27. Clamp Attachment

2. Using a 19 mm wrench, tighten the locknut securely.

See Figure 11.

3. Attach the other clamp to the external support pole

about 7 inches (140 mm) lower than the previously

installed clamp. See Figure 28 If using horizontal

external support poles, a second pole is needed.

Figure 28. Distance Between Clamps

LOCKNUT

VERTICAL

EXTERNAL

SUPPORT

POLE

ANGLED

EXTERNAL

SUPPORT

POLE

CLAMP

HORIZONTAL

EXTERNAL

SUPPORT

POLE

7.0 INCHES

(140 MM)

4. Attach the straight pole to the clamps. Tighten locknuts

on both clamps. See Figure 29.

Figure 29. Straight Pole Attachment

5. Place the offset pole (or an optional straight pole, if

desired) on top of the straight pole. Tighten knob or

bolt securely. See Figure 30.

Figure 30. Offset Pole Attachment

CLAMPS

STRAIGHT

POLE

warNINg

Always securely tighten the locknuts when assembly

is used to prevent the lighting system from falling off

which can cause injury or equipment damage.

STRAIGHT

POLE

OFFSET

POLE

KNOB

BOLT

warNINg

Always securely tighten the knob on the offset or the

bolt on the straight pole when assembly is used to

prevent the lighting system from falling off which can

cause injury or equipment damage.